Teach In" "Playback - Siemens SINUMERIK 810M Operating And Programming Manual

3 Operating Sequences
3.2.5 "TEACH IN"
...
N
• • •
3.2.6 "PLAYBACK"
Using the "PLAYBACK" function after "TEACH IN", you can program linear movements.
The position values are approached at jog traverse rate. Positions traversed to are transferred
into the program memory.
The blocks entered are transferred into the program selected in the "AUTOMATIC" basic
display.
" TEACH IN" und "PLAYBACK" can be used alternately for generating a part program.
The "TEACH IN" and the "PLAY BACK" functions are retained when changing from
"AUTOMATIC" to the "JOG" or "INC ..." modes.
When changing from the "JOG" or "INC ..." modes to "AUTOMATIC" you must reselect
"TEACH IN / PLAYBACK".
Sequence of operation
At least one complete part program block must be entered and
1, 10, 100,
1 000, 10 000
3-120
The blocks entered can be traversed using
the "Program start" key.
You can delete the blocks not required, by
entering the block no. "N ...", and operating
the delete key.
Blocks traversed correctly remain - as entered
- in the memory. They do not have to be
acknowledged.
traversed.
Set the operating mode selector switch on the external
machine control panel to one of the following symbols.
JOG
INC...
© Siemens AG 1990 All Rights Reserved
09.91
6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)