Siemens SINUMERIK 810M Operating And Programming Manual page 252

4 Monitoring Functions
4.6 Listing of the alarms/alarm description
32
Alarm No.
Alarm Text: "Data format error RS232C (V.24)"
Reason: – The permissible number of decades after an address is not correct
– The decimal point occurs in the wrong place
– The part programs or subroutines are not defined or completed
correctly (check heading!)
– The NC is waiting for an "=" character, which is not defined in EIA
code.
Effect: -Data transfer is interrupted
-The last block is not stored
Remedy: Check the data to be read in.
33
Alarm No.
Alarm Text: "Different programs same no. RS232C (V.24)"
Reason: The stored program and the program being read-in, have the same
program number, but are not identical.
Bock transfer: Program read in is unequal to selected program
Effect: No data are stored
Remedy: Either delete or "RENAME" the old program
Block transfer: Enter correct program number in Automatic basic
display
Explanation: If a new program is read-in which has the same program number as
one already stored. Both programs are compared, and because they
are different alarm 33 is displayed.
Block transfer: The program number received is compared with the
program number entered in the Automatic basic display. If they differ
alarm 33 is displayed.
34
Alarm No.
Alarm Text: "Operator error RS232C (V.24)"
Reason: Data transfer was started on the NC, but the PLC gave a second Start
signal.
Effect: No data are read in
Remedy: Stop data input, and restart
35
Alarm No.
Alarm Text: "Reader error RS232C (V.24)"
Reason: Error message from Siemens Tape Reader
Effect: -Data transfer is interrupted
-The last block is not stored
Remedy: – Restart data transfer
– If the fault reoccurs call Service
36
Alarm No.
"BTR aborted by the computer"
Alarm Text:
Reason: Part program received from BTR partner with error.
Remedy: Restart
4-10
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
09.91
6ZB5 410-0EQ02