Siemens SINUMERIK 810M Operating And Programming Manual page 116

3 Operating Sequences
3.1.5 Zero offset
b) External zero offset
The "External zero offset" values for the X, Y and Z (4th and 5th axes if present) are
transferred from the PLC.
These values can also be displayed on the screen.
Sequence of operation
SETTING
DATA
Press the "SETTING DATA" softkey
in any mode...
EXT.
ZO
... and then the "EXT. ZO" softkey.
((Bild 810M/20 einmontieren))
The "External zero offset" is defined via machine data.
3-20
This display appears on screen.
You can now read the value for the
external zero offset for the X, Y and Z
axes (4th and 5th axes, if present), but
you cannot change them.
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
09.91
6ZB5 410-0EQ02