Siemens SINUMERIK 810M Operating And Programming Manual page 36

11.90
When you operate the "Feed start" key:
•
The following values are specified in machine data:
- the feed and rapid traverse rates
- the values for the feedrate override switch positions
- whether the feedrate override switch is also active
for rapid traverse.
Direction keys/Jogging axes
– 4 +X +Z
– Y +Y
– Z – X +4
For the 5th axis there are no keys available on the integrated control
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
2.1.1 SINUMERIK 810M operator interface with integrated machine control panel
the feedrate reaches the value specified in the part program.
This key pad enables you to jog the axes
in the "JOG", "REPOS" or "INC...", modes.
• The "Feed stop" LED must
not be bright.
• The CRT shows you the specified feedrate value
"F" at which athe axes will travel when you operate
the direction keys. The value is displayed as an
abslute value, and as a "%" of the programmed
feedrate "F" (see: "Feedrate decrease / increase" in
this Section).
• You can traverse up to 2 axes simultaneously.
• In "JOG" the feed motion is arbitrary. The traverse
path is only limited by the end limit switch.
• In "REPOS" the feed motion is arbitrary (see
"JOG").
If, however, the point of interruption (in a part
program that has been partially run) is reached first,
the direction keys become inactive.
• The direction keys can traverse the axes:
– in continuous mode
– in jog mode.
panel.
6ZB5 410-0EQ02
2 Operation
2-19