Siemens SINUMERIK 810M Operating And Programming Manual page 257

01.93
2036
Alarm No.
Alarm Text: "G35 thread lead decr. error"
Reason: The pitch decrease in threading, is so high that at the end of the
thread, a diameter of less than, or equal to zero would result.
Remedy: Program either a smaller pitch decrease or a shorter thread
2037
Alarm No.
Alarm Text: "Programmed S value too high"
Reason: The programmed spindle speed "S" is higher than "16 000"
Remedy: Program a smaller spindle speed (the S value is limited to "16 000"
within the control).
2038
Alarm No.
Alarm Text: "Path feed too large"
Reason: Axis velocity too great because of the programmed path velocity.
Effect: NC START disabled and setpoint relay drops out.
Remedy: Observe permissible value range.
2039
Alarm No.
Alarm Text: "Reference point not reached"
Reason: The reference point has not been traversed to in all defined axes.
Effect: Inhibiting of NC START.
Remedy: Traverse the related axes to reference point.
Explanation: The need to traverse to reference point can be suppressed for one or
more special axes with axis-specific machine data.
Attention: Software limits are not active for these axes.
2040
Alarm No.
Alarm Text: "Block not in memory"
Reason: – During block search, the required block number was not found
– During a jump in the program, the required block number could not
Effect: be found in the given direction
Inhibiting of NC START
2041
Alarm No.
Alarm Text: "Program not in memory"
Reason: – The pre-selected program is not in the memory
– The subroutine called is not in the memory
Effect: Inhibiting of NC START
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
6ZB5 410-0EQ02
4 Monitoring Functions
4.6 Listing of the alarms/alarm description
4-15