Siemens SINUMERIK 810M Operating And Programming Manual page 139

3 Operating Sequences
3.1.10 Program input
Example: Entering an individual block.
... ...
N
• • •
0 1
G S F
9 0
G Z S
2 5
7
X D J
. .
.
etc.
+
LF
3-42
Enter the block number "N ... " using the
numerical keys, and conclude with the input
key.
Enter the first word - in the example
"G 01"- and conclude with the input key.
Enter the second word
- in the example "G 90" for "Absolute" -
and conclude with the input key.
Enter a target coordinate - in the example
"X 25" - and conclude with the input key.
etc.
You end the block with "LF" ( block end)
and conclude with the input key.
With these keys you can position the,
cursor at any point in a stored part program;
at the start of any block, or before any word
within a block.
With this key you can delete either the
complete or a single word before which the
cursor is positioned.
With this key you can modify either the
complete block or a single word before
which the cursor is positioned.
© Siemens AG 1990 All Rights Reserved
11.90
. .
.
6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)