Moving A Program ("Move") - Siemens SINUMERIK 810M Operating And Programming Manual

11.90

3.1.13.5 Moving a program ("MOVE")

Using the "MOVE" function, you move the selected program to the end of the memory.
While another program is being processed, only the program at the end
Sequence of operation
PART PROG.-
PROGRAM HANDL.
MOVE
...
%
• • •
The program selected is moved to the end of the memory.
Note:
If the cycle lock has been cancelled by the PLC, you can copy a cycle from the EPROM to the
end of the program memory with the "MOVE" function. You can then edit the cycle like a
normal part program.
As the cycle now exists twice under the identical no. L... (in the EPROM and the program
memory) the cycle in the EPROM is marked in the directory with an (*). The cycle in the
program memory has priority on selection.
The cycle in the EPROM can only be called again using the "SELECT PROGRAM" softkey
when the respective cycle has been deleted from the program memory.
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
of the memory can be modified.
Operate the "PART PROGRAM" and "PROGRAM
HANDLING" softkeys, one after the other, in any of
the operating modes:
PRESET / JOG / AUTOMATIC /
INC1... INC 10000 / REFPOINT
Using the keyboard, enter the desired program no.,
"%..." (or "L..."), and operate the "MOVE" softkey.
6ZB5 410-0EQ02
3 Operating Sequences
3.1.13 Program management
3-61