Siemens SINUMERIK 810M Operating And Programming Manual page 35

2 Operation
2.1.1 SINUMERIK 810M operator interface with integrated machine control panel
Example for the use of "Spindle stop":
•
•
•
•
When you operate the "Spindle start" key:
•
The following values are specified in machine data:
Feed hold/Feed start
When you operate the "Feed hold" key:
•
•
Example of the use of "Feed hold":
•
•
•
•
2-18
during operation in "MDI AUTOMATIC" mode, a block with a
fault is discovered
in "JOG", "INC..","REPOS" modes e.g. during
repositioning to the contour
to change a tool
to input S, T, H, M functions during setting up
(overstore)
the spindle runs at the speed specified in the part program.
- the max. spindle speed
- the values for the spindle speed override
switch positions.
the feed drives are brought to a defined standstill
the red "Feed hold" LED
during operation in "MDI AUTOMATIC" mode, a block with a
fault is discovered
in "JOG", "INC..","REPOS" modes , e.g. during repositioning to the contour
to change a tool
to input S, T, H, M functions during setting up (overstore).
© Siemens AG 1990 All Rights Reserved
lights up.
6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)
09.91