Siemens SINUMERIK 810M Operating And Programming Manual page 264

09.91
2089
Alarm No.
Alarm Text "Battery alarm abs. submod. 2"
Reason: Battery voltage is too low. Battery test is performed every 10 min.
Remedy: Replace battery module on absolute encoder module 2 while the
control is switched on.
2152
Alarm No.
Alarm Text: "Spindle speed too high"
Reason: The actual spindle speed is higher than that set in machine data.
– Program a smaller S value
– G92 S ... with v-constant
– Search for a block number in the "EDIT" mode
("AUTOMATIC"mode)
Remedy: –
2153
Alarm No.
Alarm Text: "Control loop spindle HW"
Reason: As for alarm 132*
Effect: – Inhibiting of NC START
– Operation is brought to a defined standstill
Remedy: As for alarm 132*
2154
Alarm No.
Alarm Text: "Spindle measuring system dirty"
Reason: On measuring systems with a contamination signal, the measuring
system has signalled a fault to the NC
Effect: Inhibiting of NC START
Remedy: Check the measuring system
2155
Alarm No.
Alarm Text: "Option M19 not available"
Reason: "M19 S ..." has been programmed, although this function is not
present
Effect: Inhibiting of NC START
Remedy: – Correct program
– Retrofit option "M19"
2160
Alarm No.
Alarm Text: "Scale factor not allowed"
Remedy: Modify scale factor
2161
Alarm No.
Alarm Text: "Scale change not allowed"
Remedy: Correct scale factor modification
2171
Alarm No.
Alarm Text: "Approach not possible"
Remedy: Correct approach block
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
Check or inform Service
6ZB5 410-0EQ02
4 Monitoring Functions
4.6 Listing of the alarms/alarm description
4-21