Influencing The Single Axis Dynamic Response - Siemens SINUMERIK 840D Function Manual

V1: Feedrates
5.4 Feedrate control
Note
The feedrate programmed under FB must be greater than zero.
If no traversing motion is programmed in the block (e.g. computation block), the FB has no
effect.
If no explicit feed for chamfering/rounding is programmed, then the value of FB also applies for
any contour element chamfering/rounding in this block.
Simultaneous programming of FB and FD (manual handwheel traversing with feedrate
override) or F (modal path feedrate) is not possible.
5.4.10

Influencing the single axis dynamic response

Single axes
Single axes can be programmed in the part program, in synchronized actions and via the PLC:
● Part program:
● Synchronized actions:
● PLC:
176
POS[<axis>]=...
POSA[<axis>]=...
SPOS[<axis>]=...
SPOSA[<axis>]=...
OS[<axis>]=...
OSCILL[<axis>]=...
EVERY ... DO
POS[<axis>]=...
SPOS[<spindle>]=...
MOV[<axis>]=...
FC18
Function Manual, 06/2019, A5E47437747B AA
Axes and spindles