Siemens SINUMERIK 810M Operating And Programming Manual page 141

3 Operating Sequences
3.1.10 Program input
Sequence of operation
You wish for example, to enter block "N5 G90 G00 X25 LF", into program no. "%12":
and
To do that you use the operating mode selection key, and then the corresponding softkey
(see above) or the operating mode selector switch (external machine control panel).
PART
PROGRAM
Apart from program input, the PART PROGRAM function
- Program editing (see Section 3.1.12)
- Program management (see Section 3.1.13)
- Program simulation (see Section 3.1.14).
3-44
Select one of the following operating modes:
•
PRESET (Actual value setting)
•
JOG (Feed/jog)
•
AUTOMATIC (Automatic operation)
•
INC 1 ... INC 10000 ( Incremental jog)
•
REFPOINT (Approach reference point)
Operate the "PART PROGRAM" softkey.
also serves for
© Siemens AG 1990 All Rights Reserved
11.90
6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)