Proxim ORiNOCO AP-800 Software Management Manual page 80

Tabulated below are the 'Static MAC Address Filter' parameters and the method to configure the configurable parameters:
Parameter
Wired MAC Address
Wired MAC Mask
Wireless MAC
Address
Wireless MAC Mask
Comment
Status
Click Add, to save the configured entry.
:
• A maximum of 200 Static MAC Filters can be added.
• Wired and Wireless MAC address cannot have broadcast and multicast MAC address.
5.8.3 Advanced Filters
The 'Advanced Filters' feature enables you to block the specific IP Protocol traffic on the network.
Navigate to CONFIGURATION > Filters > Advanced Filters. The Advanced Filters screen appears.
®
ORiNOCO 802.11n Access Points - Software Management Guide
Specifies the MAC address of the device on the wired network that is restricted from
communicating with a device on the wireless network. To configure, enter a Wired MAC
Address.
Specifies the range of the wired MAC addresses to which the filter is applied. To configure,
enter a Wired MAC Mask.
Specifies the MAC address of the device on the wireless network that is restricted from
communicating with a device on the wired network. To configure, enter a Wireless MAC
Address.
Specifies the range of the wireless MAC addresses to which the filter is applied. To
configure, enter a Wireless MAC Mask.
Specifies the user-comment on a Static MAC Filter table entry.
Specifies the status of the filter added. Enable the status to apply filters between the wired
and wireless devices. By default, it is enabled. To disable, click Disable from the Status box.
Figure 5-41 Advanced Filters
Description
Device Configuration
80