Proxim ORiNOCO AP-800 Software Management Manual page 72

VLAN Mode
®
ORiNOCO 802.11n Access Points - Software Management Guide
Specifies the VLAN mode to be configured on the ethernet interface. You can configure any
of the following VLAN modes on the ethernet interface:
a. Transparent Mode: Transparent Mode is configurable on the ethernet interface of
the AP device. It is equivalent to NO VLAN support and is the default mode. It is used
to connect VLAN aware/unaware networks. An interface in transparent mode forwards
both tagged and untagged frames.
To configure, select Transparent Mode from the VLAN Mode box and click OK.
b. Access Mode: Access Mode is configurable on the wireless, ethernet and
management interfaces of the AP device. This mode is used to connect VLAN aware
networks with VLAN unaware networks. In Access Mode, tagged frames with specified
Access VLAN ID going out of the AP device through the interface are untagged and
forwarded. The untagged frames coming into the AP device through the interface are
tagged with specified Access VLAN ID and forwarded.
Select Access Mode from the VLAN Mode box and click OK. The configuration
screen appears:
Configure the following properties:
Parameter
Access VLAN ID
Access VLAN
Priority
Click OK and COMMIT, to save the configured parameters.
Figure 5-33 VLAN Access Mode
Description
Specifies an access VLAN ID.
By default, it is -1, which indicates that no tag is added to
the frame. To configure, enter the Access VLAN ID either
as -1 or a value ranging from 1 to 4094.
Specifies the IEEE 802.1p priority set for the frames.
By default, it is 0. To configure, enter a value in the range
of 0 to 7.
Device Configuration
72