Proxim ORiNOCO AP-800 Software Management Manual page 106

SSH Port
SSH Sessions
Click OK and then Reboot the device for the changes to take effect.
:
• The sum of Telnet and SSH sessions cannot be more than 3.
• The Telnet and SSH Port should not be same.
6.3.3 SNMP
Navigate to MANAGEMENT > Services > SNMP and configure the following parameters:
Parameter
SNMP
®
ORiNOCO 802.11n Access Points - Software Management Guide
Specifies the number of the port on the SSH interface.
By default, the SSH Port number is 22. To configure, enter a new port.
Specifies the number of SSH sessions which controls the number of active SSH connections.
By default, the number of SSH Sessions allowed is 1. To configure, enter a value ranging
from 0 to 3.
Select Enable or Disable from the drop down menu.
– If enabled, it allows the user to access the device through SNMP Interface.
: Any change in the SNMP access will affect the NMS access.
Description
Device Management
106