Proxim ORiNOCO AP-800 Software Management Manual page 109

Version
IP Address
Password
Comment
Entry Status
Click OK and Reboot the device, if you have changed the values in the SNMP Trap Host Table.
6.3.3.1 Add a new Entry to the SNMP Trap Host Table
To add new entries to the SNMP Trap Host Table, click Add. The SNMP Trap Host Table Add Row screen appears.
®
ORiNOCO 802.11n Access Points - Software Management Guide
Priv Password
Auth Protocol
Auth Password
Click OK and Reboot the device, to save the configured parameters.
SNMP Trap Host Table
The SNMP Trap Host Table contains the following information:
Specifies the IP address to which SNMP traps will be delivered.
Specifies the password set to access the SNMP Trap Host Table entry.
: Applicable only to SNMP version v1-v2c.
Specifies the user-comment on the SNMP Trap Host Table entry.
To configure, enter any comment for the table entry.
Specifies the entry status set for each table entry.
To configure, select either Enable, Disable or Delete.
– If enabled, it allows the device to send SNMP traps to the specified IP address.
– Select Delete, if you want to delete any table entry from the SNMP Trap Host Table.
Specifies the pass key for privacy protocol selected.
The default password is public123. To configure, enter a
new password ranging from 8 to 32 characters.
: Priv Password is applicable only when the security
level is set to AuthPriv.
Specifies the type of Authentication protocol.
By default, it is SHA. To configure, select the encryption
standard as either SHA (Secure Hash Algorithm) or MD5
(Message-Digest algorithm).
Specifies the pass key for privacy protocol selected.
The default password is public123. To configure, enter a
new password ranging from 8 to 32 characters.
Device Management
109