Proxim ORiNOCO AP-800 Software Management Manual page 65

5.6.2 802.1d to IP DSCP
Navigate to CONFIGURATION > QoS > 802.1d to IP DSCP. The 802.1d to IP DSCP Mapping Table screen appears.
Tabulated below are the 'QoS 802.1d and IP DSCP (Differentiated Services Code Point) (for layer 3 policies)' parameters and
the method to configure the configurable parameters:
Parameter
802.1d to IP DSCP
Index
Lower Limit and
Upper Limit
Click OK and COMMIT, to save the configured parameters.
®
ORiNOCO 802.11n Access Points - Software Management Guide
Figure 5-26 802.1d To IP DSCP Mapping Table
Indicates the IP DSCP index corresponding to 802.1d priority. This parameter is a read-only
and cannot be configured.
Specifies the IP DSCP range (lower and Upper limit) for each 802.1d priority. To configure,
enter the Lower Limit and Upper Limit in the range of 0 to 63, respectively for each
802.1d priority.
Description
Device Configuration
65