Proxim ORiNOCO AP-800 Software Management Manual page 43

Channel Blacklist Information
A channel is blacklisted when a RADAR is detected in it. The Channel Blacklist Information table lists all the blacklisted
channels, which includes the information tabulated below.
Parameter
Channel Number
Reason
Time Elapsed
5.4.1.2 11n Properties
To configure the 11n properties of the wireless interface, navigate to CONFIGURATION > Wireless > Interface 1 > 11n
Properties. The Wireless Interface 1 11n Properties screen appears.
Tabulated below are the '11n Properties' and the method to configure the configurable parameters:
Parameter
11n AMPDU
(Aggregated MAC
Protocol Data Unit)
AMPDU Max Num
Frames
AMPDU Max
FrameSize
®
ORiNOCO 802.11n Access Points - Software Management Guide
Specifies the channel number of the blacklisted channel.
Specifies the reason for blacklisting a channel.
Specifies the time period, during which a channel is not operational.
Figure 5-10 Wireless Interface 1 11n Properties
This parameter enables the user to aggregate several MAC frames into a single large frame
to achieve high throughput.
By default, AMPDU status is enabled. To disable, select Disable from the drop down menu.
Specifies the maximum number of frames that are aggregated and transmitted as a single
Protocol Service Data Unit (PSDU) by the physical layer.
By default, the AMPDU Max Num Frames is 64. To configure, enter a value ranging from 2
to 64 frames.
Specifies the maximum AMPDU frame size (in bytes) that can be transmitted.
By default, the AMPDU Max FrameSize is 65535 bytes. To configure, enter the frame size
ranging from 1k to 64k bytes.
Description
Description
Device Configuration
43