Proxim ORiNOCO AP-800 Software Management Manual page 88

Default Lease Time
Status
Start IP Address
End IP Address
Delete
Click OK and COMMIT, to save the configured parameters.
5.9.1.1 Add an Entry to DHCP Pool Table
To add an entry to the DHCP Pool Table, click Add in the DHCP Server screen. The DHCP Pool Table Add Row screen
appears.
Configure the following parameters:
Parameter
Pool Interface
Start IP Address
®
ORiNOCO 802.11n Access Points - Software Management Guide
Specifies the least time provided by the DHCP server, to the DHCP client on that interface.
By default, it is 86400 seconds. To configure, enter a value in the range 3600 to 172800
seconds.
: If the 'Default Lease Time' value is greater than 'Max Lease Time', then the DHCP
server assigns the Max Lease Time to the DHCP client.
Specifies the status of DHCP server functionality over the interface.
By default, it is disabled. To configure, select Enable or Disable from the drop down menu.
The DHCP Pool Table contains the following information:
Specifies the Start IP Address of the pool.
Specifies the End IP Address of the pool.
This parameter allows you to delete the added pool entry.
:
• A pool entry can be deleted but not edited.
• To enable DHCP Server, atleast one pool must be configured.
Figure 5-48 DHCP Pool - Add an Entry
Specifies the interface type (ethernet or wireless). The device supports only Bridge mode.
DHCP Pool Table
See
DHCP Pool Table
Description
Device Configuration
88