Proxim ORiNOCO AP-800 Software Management Manual page 30

Primary IP Address
Secondary IP
Address
Click OK and COMMIT, to save the configured parameters.
: If you have changed any of the TCP/IP parameters, then reboot the device.
5.2.2 Link Integrity
Link Integrity helps you to check connectivity between the AP device and its pre-configured servers (routers, gateway
devices and other devices in the vicinity), by sending ICMP (Internet Control Message Protocol) echo probes periodically. If the
device receives an acknowledgment from a server within the configured time interval, then the link between that server and
the AP device is active and the link integrity status is set to UP, otherwise it is set to DOWN.
If atleast one server responds back, then the over all Link Status is set to UP and the device performs standard AP functionality.
If all the servers configured fail to respond, then the over all Link Status is set to DOWN and all the VAPs enabled in AP mode
are disabled. (VAPs in WDS mode remain unaffected. See
Status is set to UP.
Navigate to CONFIGURATION > Network > Link Integrity. The Link Integrity screen appears.
®
ORiNOCO 802.11n Access Points - Software Management Guide
Specifies the IP Address of the Primary DNS Server. When the address type is set to
Dynamic, this parameter is read-only and displays the DNS Primary IP Address obtained from
the DHCP server.
If the Address Type is set to Static then you will have to manually enter the IP Address in the
Primary IP Address box.
Specifies the IP Address of the Secondary DNS Server. When the address type is set to
Dynamic, this parameter is read-only and displays the DNS Secondary IP Address obtained
from the DHCP server.
If the Address Type is set to Static then you will have to manually enter the IP Address in the
Secondary IP Address box.
Figure 5-4 Link Integrity
Virtual Access Point (VAP)). The VAPs in AP mode resume as Link
Device Configuration
30