Proxim ORiNOCO AP-800 Software Management Manual page 111

Configure the following parameters:
Parameter
Log Status
Log Priority
IP Address
Port
Host Comment
Entry Status
Click OK and COMMIT, to save the configured parameters.
6.3.4.1 Add a new Entry to the SYSLOG Host Table
To add new entries to the SYSLOG Host Table, click Add. The SYSLOG Host Table Add Row screen appears.
®
ORiNOCO 802.11n Access Points - Software Management Guide
Specifies the status of the system log.
To configure, select either Enable or Disable from the drop down menu. If enabled, it
allows the device to generate log messages.
Specifies the priority assigned to the log. The available log priorities are:
– Emergency
– Alert
– Critical
– Error
– Warning
– Notice
– Info
– Debug
Please note that the priorities are listed in the order of their severity, where Emergency takes
the highest severity and Debug the lowest.
To configure, select the Log Priority from the drop down menu.
SYSLOG Host Table Entries
The SYSLOG Host Entries Table contains the following information:
Specifies the IP address of the SYSLOG server.
Specifies the host port number. The default port is 514.
: The user must configure the correct port number on which the SYSLOG server is
running for the Host Port parameter. Choice of port number must be in line with the
standards for port number assignments defined by Internet Assigned Numbers
Authority (IANA).
Specifies the user-comment on the SYSLOG Host Table entry. To configure, enter any
comment for the table entry.
Specifies the entry status set for each table entry. To configure, select either Enable, Disable
or Delete.
– If enabled, it allows the device to send SysLog messages to the specified IP address of
the SYSLOG server.
– Select Delete, if you want to delete any table entry from the SYSLOG Host Table.
Description
Device Management
111