Proxim ORiNOCO AP-800 Software Management Manual page 145

Follow the following steps to assign an IP address to the device:
1. Open your terminal emulation program and set the following connection properties:
• Com Port: COM1, COM2 and so on depending on your computer
• Baud Rate: 115200
• Data Bits: 8
• Stop Bits: 1
• Flow Control: None
• Parity: None
2. The terminal display shows Power On Self Tests (POST) activity, and then displays the software version. It prompts you
to enter the CLI username and password. The commands to enter the username and password are as follows.
Username: admin
Password:
This process may take up to 90 seconds.
3. Enter the CLI Username and password (By default username is admin and password is public). The terminal displays a
welcome message and then the CLI Prompt.
4. Enter the following CLI command for the current IP Address of the device.
AP-00:7D:09
5. Change the IP address and other network values by using the following CLI commands (use your own IP Address and
Subnet Mask)
AP-00:7D:09>enable
AP-00:7D:09#configure
AP-00:7D:09(config)# network
AP-00:7D:09(config-net)# ip
AP-00:7D:09(config-net-ip)# ethernet-ip-table rowedit 1
Possible completions:
<[Enter]>
address-type
ipaddress
mask
AP-00:7D:09(config-net-ip-etherip)# rowedit 1 ipaddress <IP Address>
Changes in Ethernet IP Address requires reboot.
AP-00:7D:09(config-net-ip-etherip)# rowedit 1 mask <Subnet Mask>
Changes in Ethernet Subnet mask requires reboot.
AP-00:7D:09(config-net-ip-etherip)# rowedit 1 address-type <static/dynamic>
Changes in Ethernet IP Address Type requires reboot.
AP-00:7D:09(config-net-ip-etherip)#exit
AP-00:7D:09(config-net-ip)# default-gateway <IP Gateway>
AP-00:7D:09(config-net-ip)#exit
AP-00:7D:09(config-net)#exit
For Commit and Reboot,
®
ORiNOCO 802.11n Access Points - Software Management Guide
>
show ip
Execute this command
Configure the Address type
IP Address of the network interface
subnet mask of the network interface
Troubleshooting
145