Proxim ORiNOCO AP-800 Software Management Manual page 29

Tabulated below are 'Network IP' parameters and the method to configure the configurable parameters:
Parameter
Address Type
IP Address
Subnet Mask
Gateway IP Address
®
ORiNOCO 802.11n Access Points - Software Management Guide
Figure 5-3 Network IP Configuration
By default this parameter is set to Dynamic. When set to dynamic, the device will obtain IP
settings from a network Dynamic Host Configuration Protocol (DHCP) server automatically
during the boot-up.
If you do not have a DHCP server or if you want to manually configure the device IP address,
set this parameter to Static.
Specifies the IP Address of the device. When the address type is set to Dynamic, this
parameter is read-only and displays the device's current IP address obtained from the DHCP
server. The device will be set to the default IP address 169.254.128.132, if the device cannot
obtain the IP address from a DHCP server.
If the Address Type is set to Static then you will have to manually enter the IP Address in the
IP Address box.
Specifies the device subnet mask. When the address type is set to Dynamic, this parameter
is read-only and displays the device current subnet mask obtained from the DHCP server. The
device will be set to the default subnet mask 255.255.0.0, if the device cannot obtain the
subnet mask from a DHCP server.
If the Address Type is set to Static then you will have to manually enter the subnet mask in
the Subnet Mask box.
Specifies the IP address of the device gateway. When address type is set to Dynamic, this
parameter is read-only and displays the IP address of the device gateway. The device will be
set to the default Gateway IP address 169.254.128.133, if it cannot obtain the gateway IP
address from a DHCP server.
If the Address Type is set to Static then you will have to manually enter the gateway IP
address in the Gateway IP Address box.
Description
Device Configuration
29