Proxim ORiNOCO AP-800 Software Management Manual page 144

: Optionally, you can enable Send line ends with line feeds (CTRL+F) under File > Properties > Settings >
ASCII Setup, to allow the Terminal Emulator program send a line return at the end of each line of code.
Enter the following CLI commands:
Bootloader=> show(to view configuration parameters and values)
Bootloader=> set ipaddr <Access Point IP Address>
Bootloader=> set serverip <TFTP Server IP Address>
Bootloader=> set filename <Device Image File Name, including file
Bootloader=> set gatewayip <Gateway Ip Address>
Bootloader=> set netmask <Network Mask>
Bootloader=> set ipaddrtype static
Bootloader=> show (to confirm your new settings)
Example:
Bootloader=> show
Bootloader=> set ipaddr 169.254.128.132
Bootloader=> set serverip 169.254.128.133
Bootloader=> set filename apimage_proxim.sei
Bootloader=> set gatewayip 169.254.128.133
Bootloader=> set netmask 255.255.255.0
Bootloader=> set ipaddrtype static
Bootloader=> show
Bootloader=> reboot
6. The device will reboot and then download the image file.
7. When the download process is complete, configure the device.
8.4.4 Setting IP Address by Using a Serial Port
: 'Setting IP Address by using a Serial Port', is not applicable for AP-8100.
Use the following procedure to set an IP address for the device by using the CLI. The Network Administrator typically provides
the device IP address.
•
Hardware and Software Requirements
— Standard serial (RS-232) cable (not included in the Product Package).
— ASCII Terminal software.
•
Attaching the Serial Port Cable
— Connect one end of the serial cable to the device and the other end to a serial port on your computer.
— Power on the computer and the device.
•
Initializing the IP Address by using CLI
After connecting the cable to the serial port, you can use the CLI to communicate with the device. CLI supports the
most-generic terminal emulation programs. In addition, many web sites offer shareware or commercial terminal
programs that you can download. Once the IP address has been assigned, you can use the HTTP interface or the Telnet
to complete the configuration.
®
ORiNOCO 802.11n Access Points - Software Management Guide
extension>
Troubleshooting
144