Proxim ORiNOCO AP-800 Software Management Manual page 82

Modify the Direction and Status of the desired IP Protocol. Click OK and COMMIT, to save the configured parameters.
5.8.4 TCP/UDP Port Filters
Port-based filtering enables you to control wireless user access to network services by selectively blocking TCP/UDP protocols
through the device. A user specifies a Protocol Name, Port Number, Port Type (TCP, UDP, or TCP/UDP), and filtering interfaces
(Only Wireless, Only Ethernet or Both) in order to block access to services such as Telnet and FTP, and traffic such as NETBIOS
and HTTP.
For example, a device with the following configuration would discard frames received on its ethernet interface with a UDP
destination port number of 137, effectively blocking NETBIOS Name Service packets.
Navigate to CONFIGURATION > Filters > TCP/UDP Port Filters. The TCP / UDP Port Filters screen appears.
®
ORiNOCO 802.11n Access Points - Software Management Guide
Figure 5-42 Advanced Filters - Edit Entries
Protocol Port
Name Number
NETBIOS 137
Name Service
Port Filter Entry Status
Type Interface (Enable/Disable)
UDP Ethernet
Device Configuration
Enable
82