Proxim ORiNOCO AP-800 Software Management Manual page 163

Q. Can I perform the background Rogue Scan on both the radios (where, radio 1 = 5 GHz and radio 2 = 2.4 GHz)
at the same time?
Yes. You can perform the Rogue Scan on both the wireless interfaces (radios) at the same time.
Q. Does Rogue Scan apply on a WDS enabled radio?
Yes. Rogue Scan can be applied on a WDS enabled radio.
Q. Does Rogue Scan apply on the adjacent channels, if it is set to Current Channel Scan?
No. Rogue Scan is not applied on the adjacent channels, if it is set to Current Channel Scan.
Q. Where I can find the Rogue Scan results?
In the Web (HTTP) Interface, navigate to Monitor -> Rogue Scan -> Interface.
Q. How does the Rogue Scan feature on AP device, detect the Wi-Fi interferences?
i) For AP Devices: AP Devices are detected based on beacons, which has IBSS field set to 0
ii) For STA Devices: STAs (Stations) are detected based on data packets which has TO DS bit=1.
: All probe request packets are considered as STAs.
iii) For WDS Devices: WDS Devices are detected based on data packets which has 4 address format (with 2 MAC address in
the header).
iv) For ADHOC Devices: ADHOC Devices are detected based on beacons, which has IBSS field set to 1.
Q. If the radio is configured in 5GHz and Rogue Scan is set to All Channel Scan, then does the Rogue Scan feature
on the AP device scan a 2.4GHz channel?
•
For AP-800/AP-8000: Yes. Rogue Scan is applicable on both 2.4 GHz and 5GHz channels in All Channel scan mode,
irrespective of the frequency band configured on the radio.
•
For AP-8100: No. Rogue Scan feature will only scan 5GHz channels on radio 1 and 2.4 GHz channels on radio 2.
Q. How to enable Rogue Scan on the AP device?
Navigate to Configuration -> Wireless Interface -> Properties -> Rogue Scan Status. Select "Current Channel Scan"
or "All Channel Scan"
®
ORiNOCO 802.11n Access Points - Software Management Guide
Frequently Asked Questions (FAQs)
163