Proxim ORiNOCO AP-800 Software Management Manual page 87

Navigate to CONFIGURATION > DHCP > DHCP Server. The DHCP Server screen appears.
Tabulated below are the 'DHCP Server' parameters and method to configure the configurable parameters:
Parameter
DHCP Server Status
Max Lease Time
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
®
ORiNOCO 802.11n Access Points - Software Management Guide
Figure 5-47 DHCP Server
Specifies the status of the DHCP Server functionality on the device. By default, it is disabled.
To configure, select Enable or Disable from the drop down menu.
: If DHCP Server Status is enabled, it is recommended to set the IP address manually
(Static IP Address). See
The IP address assigned by the DHCP server is valid till the configured maximum lease time.
By default, the Max Lease Time is 86400 seconds. To configure, enter a value in the range
3600-172800 seconds.
DHCP Interface Settings
The DHCP Interface Settings Table contains the following information:
Specifies the subnet mask forwarded to the client along with the assigned IP address. The
netmask configured here should be greater than or equal to the netmask configured on the
interface. To configure, enter the subnet mask.
Specifies the default gateway address forwarded to the client along with the assigned IP
address. Default Gateway is a node that serves as an accessing point to another network. To
configure, enter the Default Gateway address.
Specifies the primary DNS (Domain Name Server) IP address forwarded to the client. To
configure, enter the Primary DNS address.
Specifies the secondary DNS IP address to be sent to the client. To configure, enter the
Secondary DNS address.
Description
Assigning the IP Address Manually
Device Configuration
87