Proxim ORiNOCO AP-800 Software Management Manual page 71

Management VLAN
ID
Management VLAN
Priority
Click OK and COMMIT, to save the configured parameters.
:
• When VLAN is enabled, ensure that all nodes in the network share the same VLAN ID as this will ensure that all the
access points are managed easily.
• In the case of RADIUS server authentication or EAP authentication, if the RADIUS server is present on any VLAN, then
the RADIUS server should be member of the management VLAN ID of AP device.
5.7.1 VLAN Ethernet Configuration
To enable VLAN on the ethernet interface, navigate to CONFIGURATION > VLAN > Ethernet. The VLAN Ethernet
Configuration screen appears.
Tabulated below are the 'VLAN Ethernet' parameters and the method to configure the configurable parameters:
Parameter
Interface
®
ORiNOCO 802.11n Access Points - Software Management Guide
: It is recommended to configure the VLAN-Ethernet in Trunk mode, when
RADIUS VLAN is enabled. This reduces the interference problems, by
sending the VLAN traffic (broadcast/multicast) only to the intended
wireless clients.
Specifies the Management VLAN ID. The wireless clients must tag the management frames
sent to the AP device, along with the management VLAN ID.
By default, the Management VLAN ID is set to -1; which indicates that no tag is added to the
management frame. To enable, enter a value ranging from 1 to 4094.
: If a non-zero management VLAN ID is configured, then management access to the
AP device is restricted to wired or wireless hosts that are members of the same
VLAN. Ensure your management platform or host is a member of the same VLAN,
before attempting to manage the AP device.
Specifies the IEEE 802.1p priority set for the management frames. By default, it is set to 0. To
configure, set the VLAN priority in the range of 0 to 7.
Figure 5-32 VLAN Ethernet Configuration
A read-only parameter that represents the interface on which VLAN is configured.
Description
Device Configuration
71