Set Basic Configuration Parameters Using Cli Commands - Proxim ORiNOCO AP-4000M User Manual

Command Line Interface (CLI)
Configuring the AP using CLI commands

Set Basic Configuration Parameters using CLI Commands

There are a few basic configuration parameters that you may want to setup right away when you receive the AP. For
example:
• Set System Name, Location and Contact Information
• Set Static IP Address for the AP
• Download an AP Configuration File from your TFTP Server
• Set up Auto Configuration
• Set Network Names for the Wireless Interface
• Enable 802.11d Support and Set the Country Code
• Enable and Configure TX Power Control for the Wireless Interface(s)
• Configure SSIDs (Network Names), VLANs, and Profiles
• Download an AP Configuration File from your TFTP Server
• Backup your AP Configuration File
Set System Name, Location and Contact Information
NOTE: System name must:
• Contain only letters, numbers, and hyphens.
• Be limited to 31 characters.
• Not begin with a number or hyphen.
• Not contain blank spaces.
[Device-Name]>set sysname <Name> sysloc <Unit Location>
[Device-Name]>set sysctname <Contact Name>
[Device-Name]>set sysctphone <Contact Phone Number> sysctemail <Contact E-mail address>
[Device-Name]>show system
Figure A-12 Result of "show system" CLI Command
Set Static IP Address for the AP
NOTE: The IP Subnet Mask of the AP must match your network's Subnet Mask.
[Device-Name]>set ipaddrtype static
[Device-Name]>set ipaddr <fixed IP address of unit>
[Device-Name]>set ipsubmask <IP Mask>
[Device-Name]>set ipgw <gateway IP address>
[Device-Name]>show network
Change Passwords
[Device-Name]>passwd <Old Password> <New Password> <Confirm Password> (CLI password)
[Device-Name]>set httppasswd <New Password> (HTTP interface password)
AP-4000/4000M/4900M User Guide
205