Switch Firmware Upgrade Example - Lenovo SI4091 Installation Manual

Switch Firmware Upgrade Example

1. Log in to the switch (see
information).
2. At the switch Command-Line Interface (CLI) prompt, execute the following
commands to upload the firmware image to the switch.
3. Execute the following command to upload the boot image to the switch.
4. Reset and restart the switch as described in
on page
© Copyright Lenovo 2016
To upgrade the switch firmware, complete the following steps.
SI 4091> enable
SI 4091# copy {ftp|tftp|sftp} {image1|image2} addr <server address> file
<image file> {data-port|extm-port|mgt-port}
Where server address is the IP address of file server, and image file is the file name
of the firmware image as it appears in the file server operating-system.
SI 4091# copy {ftp|tftp|sftp} boot addr <server address> file <boot file>
{data-port|extm-port|mgt-port}
Where boot file is the file name of the boot image as it appears in the file server
operating-system.
44.
"Configuring the SI4091" on page 31
"Resetting and Restarting the Switch"
for more
Chapter 4: Updating the Firmware
43