Managing the Stack
Accessing the Master Switch CLI
Rebooting Stacked Switches via the Master
Rebooting Stacked Switches using the ISCLI
Rebooting Stacked Switches using the BBI
© Copyright Lenovo 2017
The stack is managed primarily through the Master switch. The Master switch then
pushes configuration changes and run‐time information to the Member switches.
To access the Master switch, use Telnet or the Browser‐Based Interface (BBI) as
follows:
Use the serial console.
On any switch in the stack, connect to any port that is not part of an active LAG
and is a member of a VLAN. To access the stack, use the IP address of any IP
interface that is member of the VLAN.
The administrator can reboot individual switches in the stack, or the entire stack
using the following commands:
RS 8264CS(config)# reload
RS 8264CS(config)# reload master
RS 8264CS(config)# reload switch <csnum list>
The Configure > System > Config/Image Control window allows the
administrator to perform a reboot of individual switches in the stack, or the entire
stack. The following table describes the stacking Reboot buttons.
Table 22.
Stacking Boot Management buttons
Field
Description
Reboot Stack
Performs a software reboot/reset of all switches in the stack.
The software image specified in the Image To Boot drop‐down
list becomes the active image.
Reboot Master
Performs a software reboot/reset of the Master switch. The
software image specified in the Image To Boot drop‐down list
becomes the active image.
Reboot Switches Performs a reboot/reset on selected switches in the stack. Select
one or more switches in the drop‐down list, and click Reboot
Switches. The software image specified in the Image To Boot
drop‐down list becomes the active image.
The Update Image/Cfg section of the window applies to the Master. When a new
software image or configuration file is loaded, the file first loads onto the Master,
and the Master pushes the file to all other switches in the stack, placing it in the
(Reboot all switches in the stack)
(Reboot only the stack Master)
(Reboot only the listed switches)
Chapter 15: Stacking
263