Keypad Menu Structure - gefran VDI100 Series Instruction Manual

4.2.2.

Keypad Menu Structure

Main Menu
The VDI100 inverter main menu consists of two main groups (modes). The DSP/FUN key is used to switch
between the monitor mode and the parameter group mode.
Power On
Power-up
Monitor Mode
Parameter Group Mode
All the available parameter groups are listed in the Parameter Group Mode use the up and down keys to select
a group and press Read/Enter key to access its parameters.
Note ! - Always perform an auto-tune on the motor before operating the inverter in vector control (sensorless vector or flux vector).
Auto-tuning mode will not be displayed when the inverter is running or when a fault is active.
- To scroll through the available modes, parameter groups or parameter list press and hold the up or down key.
Monitor Mode
In monitor mode inverter signals can be monitored such as output frequency, output current and output voltage,
etc...) as well as fault information and fault trace. See Fig 4.2.2.2 for keypad navigation.
Group
00 Basic Func.
01 V/F Pattern.
02 Motor Parameter
52
Monitor Mode
Mode
Parameter Group Mode
READ
DSP
ENTER
FUN
Parameter Mode
READ
DSP
ENTER
FUN
Parameter Edit Mode
Fig. 4.2.2.1 Parameter Group Structure
DSP
FUN
DSP
FUN
Parameter Group Mode
View inverter status, signals and fault data.
Access to available parameter groups.
Select parameter group
Select parameter
Change parameter setting
Power ON
Monitor
DSP
FUN
Freq Ref
12-16=005.00Hz
12-17=000.00Hz
12-18=0000.0A
Monitor
DSP
FUN
Flt Freq Ref
12-15=000.00Hz
12-17=000.00Hz
12-18=0000.0A
Monitor
DSP
FUN
Flt DC Voltage
12-14=0000.0V
12-17=000.00Hz
12-18=0000.0A
Fig 4.2.2.2 Monitor Mode
DSP
FUN
Description
VDI100 • Instruction manual