gefran VDI100 Series Instruction Manual page 251

■ WRITE: Copy Keypad parameters to the Inverter
Steps
Group
14 PLC Setting
1
15 PLC Monitor
16 LCD Keypad Func.
PARA
-07：Copy Sel
2
-08：READ Sel
-09：Keypad Loss Sel
Edit
3
0
(0 – 3)
< 0 >
Edit
4
2
(0 – 3)
< 0 >
-ADV-
5
-ADV-
6
Edit
7
2
(0 – 3)
< 0 >
■ Verify: Compare Inverter Parameters against Keypad Parameters
Steps
Group
14 PLC Setting
1
15 PLC Monitor
16 LCD Keypad Func.
PARA
-07：Copy Sel
2
-08：READ Sel
-09：Keypad Loss Sel
VDI100 • Instruction manual
Keypad (English)
Select the copy function group (16) from the group menu.
16
Press the Read / Enter key and select parameter (16-07) copy sel.
16-07
Copy Sel
Press the Read / Enter key to display the data setting / read screen (LCD display is
inversed).
Normal
16-07
Copy Sel
Change the set value to 2 (write) by using the up arrow key.
WRITE
WRITE
• Use Read / Enter key to enable the read operation, the display is shown as the left.
INV → OP
• The bottom of LCD display will show a bar to indicate the read progress.
WRITE
"WRITE COMPLETE" will be displayed on the keypad when writing was successful.
COMPLETE
• The error message of "WRE Write Error " may occur on the keypad when writing
WRE
parameters to the inverter is prohibited.
Write Error
• If the error is displayed, press any key to remove the error message and go back to
parameter 16-07.
16-07
Copy Sel
When DSP/FUN key is pressed, the display returns to parameter 16-07.
WRITE
Keypad (English)
Select the copy function group (16) from the group menu.
16
Press the Read / Enter key and select parameter (16-07) copy sel.
Description
Description
251