Monitoring Parameters - gefran VDI100 Series Instruction Manual

12 - Monitoring Parameters

Code Parameter Name / Range
12-00 Display screen selection (LED)
Highest digit => 0 0 0 0 0 <= lowest digit
The value range of each digit is 0~7 from the highest to the lowest,
0: Default display (frequency&parameters)
1: Output current
2: Output voltage
3: DC bus voltage
4: Heatsink temperature
5: PID feedback
6: Analog Signal Input. (AVI)
7: Analog Signal Input. (ACI)
Note:
The highest bit is used for power-up monitor. The 4 least significant bits can be used to customize the display se-
quence see chapter 4.1.3.
Code Parameter Name / Range
12-01 PID feedback display mode (LED)
0: Display the feedback value in integer (xxx)
1: Display the feedback value with one place after the decimal point (xx.x)
2: Display the feedback value (x.xx) with two places after the decimal point
12-02 PID feedback display unit setting (LED)
0: xxxxx (no unit)
1: xxxPb (pressure)
2: xxxFL (flow)
12-05 Status display of digital input terminal (LED / LCD)
Read-only
Terminals S1-S8 are represented using two segments of each digit. Segment turns on when input is active.
The bottom segments of each of the first three digits are used to represent the digital outputs (R1, R2, DO1).
Segments turn on when output is active.
Example1:
S1~S8, R1, R2 and DO1 are ON
Note:
Refer to section 4.3 for monitors 12-11~12-64.
Monitoring parameter 12-66: Encoder Angle
Encoder PG pulse (20-27) is set to correct connection with the encoder wiring. Make the motor rotate forwardly
at non-run state and the angle will accumulate to 360°at two times; if make the motor rotate reversely, the angle
will regress to 360° at two times.
Monitoring parameter 12-67: Cumulative Energy (kWHr) & 12-68: Cumulative Energy (MWHr)
VDI100 • Instruction manual
Example 2:
S1~S8, R1, R2 and DO1 are OFF
0 0 0 0 0 0 0 0 0 0 0
0: OPEN
1: CLOSE
Input Terminal(S8)
Input Terminal(S7)
Input Terminal(S6)
Input Terminal(S5)
Input Terminal(S4)
Input Terminal(S3)
Input Terminal(S2)
Input Terminal(S1)
Output Terminal(DO1)
Output Terminal(R2)
Output Terminal(R1)
239