Optional Keypad Interface (Keypad Connector) - gefran VDL200 Series Quick Start Up Manual

Connection to a PC with RS232 port (not isolated)
The following are required for connection:
• a shielded cable (cod. 8S864C L=4.5mt; cod. 8S874C L=10mt) for connection to the RS232 PC port of the drive to
the RS232 connector of the PC, see figure 7.4.1-B.
Connection to a PC with USB port (not isolated)
The following are required for connection:
• an optional USB/RS232 adapter, code 8S8F62 (including the cable for USB connection)
• a shielded cable (cod. 8S864C L=4.5mt; cod. 8S874C L=10mt) for connection to the RS232 PC port of the drive to
the USB/RS232 adapter, see figure 7.4.1-C.

7.5 Optional Keypad interface (keypad connector)

Several devices can be connected to the multifunction keypad connector (9-pin D-SUB receptacle connector XS1) and
are automatically recognised and managed.
1) Optional KB-ADL keypad (default connection)
- The keypad is supplied with a 40 cm-long cable, for longer distances, a 1:1 non-crossover cable must be used (9
shielded cables, e.g. code 8S8F59, length 5 m).
- Very long cables (max. 15 m) must be of good quality with low voltage loss (max. 0.3 ohm/m).
2) I/F DCP protocol
- For the connection reference should be made to the DCP specifications (see next screen)
The connections (1) and (2) have no galvanic isolation!
Caution
34
XS1
5
9
Figure 7.5.3: DCP connection (not isolated)
VDL200 • Quick installation guide - Specifications and connection
1 5
Keypad
6 9
TxA
TxB
GND
4 2 1
3
8 7 6
connector (XS1)