®
R&S
NGL200
Figure 6-2: Voltage and current settings in the instrument
6.2 Activating the Channels Output
The outputs of all the channels (Ch1, Ch2) can be switched on or off by toggling the
[Output] key on the front panel.
By default, the output is turned off when the instrument is switched on. The output is
also automatically turned off when no channel is selected. This design prevents a con-
nected load from being damaged unintentionally.
1. Press the required channel keys.
Selected channel keys (Ch1, Ch2) illuminate.
2. Press [Output] key.
The R&S NGL200 output the set voltage of the selected channel.
Depending on the operating mode, the font text in the channel display area shows
green when in CV mode, red when in CC mode and blue when in CR mode.
Note: The R&S NGL200 goes into CR mode when operated in sink mode.
See
User Manual 1178.8736.02 ─ 02.01
Chapter 5.5, "Output
Modes",
Activating the Channels Output
on page 37.
Instrument Functions
40