R&S NGL200 series User Manual page 25

®
R&S NGL200
AC inlet with fuse holder and voltage selector (8)
Main supply cord
Do not use detachable mains supply cord with inadequate rating.
For safety reasons, the instrument can only be operated with authorized safety sock-
ets.
The power cable must be plugged in before signal circuits can be connected. Never
use the product if the power cable is damaged. See
Instrument",
The built-in voltage selector selects the mains voltage between 100 V, 115 V and 230
V. All voltage settings are using the same fuse rating.
Channel connectors (9, 10)
Output Terminals
Either the output terminals at the front panel or those at the back panel can be used.
Using both terminals at the same time can cause instrument malfunction.
DVM pins on the channel connector are only available in the NGM types power supply.
The channel connectors contain both output ("F+", "F-") and sense ("S+", "S-") connec-
tions. Connector for "Ch 2" is only available in the R&S NGL202 model.
USB connectors (11, 12)
The USB host connector (Type-A) can be used for mass storage devices like the USB
connector at the front panel.
The USB device connector is a Type-B connector for remote control operation.
Ethernet connector (13)
This connector is used for establishing remote control via SCPI.
See section "Ethernet Setup" in the user manual for more information on the connec-
tion setup.
Option GPIB interface (14)
An IEEE488 GPIB interface can be ordered (NGL-B105). This interface is not user
installable.
User Manual 1178.8736.02 ─ 02.01
on page 23 for more information.
Getting Started
Instrument Tour
Chapter 4.2.2, "Switching On the
22