R&S NGL200 series User Manual page 30

®
R&S NGL200
Device status bar
Function
GPIB/IEEE488 interface
SCPI command
USB host interface
Data Logger
USB device interface
Ethernet/LAN interface
Time
Touchscreen
Channel status bar
Function
Channel number
Operation mode
"Over Current Protection" (OCP),
User Manual 1178.8736.02 ─ 02.01
Description
If GPIB/IEEE488 interface is installed, the icon is
highlighted in white.
If active, the icon is highlighted in white.
If an error is in the remote command, the icon is
highlighted in red.
See Chapter 7, "Remote Control
on page 79.
If USB stick is present, the icon is highlighted in
white.
If data logging is present, the icon is highlighted in
white.
If an error is present, the icon is highlighted in red.
See Chapter 6.7, "Data Logger",
If a host command is received in USB interface, the
icon is highlighted in white.
If active, the icon is highlighted in white.
See Chapter 6.10, "Interfaces",
Display of time in hh:mm:ss format.
See Chapter 6.11.4, "Date and
If disabled, the icon is highlighted in white.
See Chapter 5.2, "Using the
on page 30.
Description
Indication of channel 1 or channel 2 display.
The R&S NGL200 has three operating modes:
●
CV: Constant voltage mode
●
CC: Constant current mode
●
CR: Constant resistance mode. The
R&S NGL200 goes into this mode when oper-
ates in sink mode and the "Constant Resist-
ance" mode is activated.
For more information, see Chapter 5.5, "Output
Modes", on page 37.
If enabled, the icon is highlighted in white.
If triggered, the icon blinks.
See Chapter 6.3.1, "Over Current Protection
(OCP)", on page 45.
Operating Basics
Display Overview
Commands",
on page 61.
on page 67.
Time", on page 76.
Touchscreen",
27