®
R&S
NGL200
Figure 6-23: Target folder dialog
●
●
7. Set the required target folder.
8. Select "Set" to confirm the selection.
9. Select "Mode" to set logging duration.
●
●
●
●
10. Depending on the mode selected, configure the required settings for the logging
duration.
11. Set the "CSV Settings".
See
12. Only applicable with R&S NGL-K103, Digital Output option, see
"Digital
Activated the "Triggered" if logging of data is to be excuted under triggered condi-
tions.
If activated, the R&S NGL200 will execute the logging of data when a trigger is
detected.
13. Select "Enabled" to activate the file logging function.
The R&S NGL200 starts the data logging and displays the "data logging" icon at
the device status bar information.
Note: The data logging dialog is not configurable if logging is enabled.
6.7.1 CSV Settings
User Manual 1178.8736.02 ─ 02.01
"USB1A": Target folder is set to /USB1/NGM202/logging.
"int": Target folder is set to /int/logging.
"Duration": Time taken for data logging with duration and time interval setting.
"Span": Time taken for data logging with start time, time interval and duration
setting
"Unlimited": Data logging with time interval setting. The data logging continuous
until function is deactivated.
"Count": Data logging with number of counts and time interval setting
Chapter 6.7.1, "CSV
Settings",
I/O",
on page 54.
on page 62.
Instrument Functions
Data Logger
Chapter 6.4.3,
62