R&S NGL200 series User Manual page 92

®
R&S NGL200
// selects the output channel, sets the step width
// and increases the voltage in the selected channel
// by the set 4 Volts
VOLT DOWN
// decreases the voltage in the selected channel
// by the set 4 Volts
VOLT:STEP?
// queries the voltage step size
// repsonse: "4.000"
[SOURce:]ALIMit[:STATe]
[SOURce:]VOLTage[:LEVel][:IMMediate]:ALIMit:LOWer
[SOURce:]VOLTage[:LEVel][:IMMediate]:ALIMit[:UPPer]
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
[SOURce:]VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
[SOURce:]ALIMit[:STATe] <state>
[SOURce:]ALIMit[:STATe]?
Activates/Deactivates or Queries the safety limit for voltage.
Parameters:
<state>
Example:
[SOURce:]VOLTage[:LEVel][:IMMediate]:ALIMit:LOWer <voltage>
[SOURce:]VOLTage[:LEVel][:IMMediate]:ALIMit:LOWer?
Sets/Queries the lower safety limit for voltage.
Setting parameters:
<voltage>
Example:
User Manual 1178.8736.02 ─ 02.01
..................................................................................................89
1 | 0
1
Activates the safety limit for voltage.
0
Deactivates the safety limit for voltage.
See Example "Configuring the output voltage"
numeric | MIN | MAX
numeric
Numeric value for safety limit.
MIN
Min value for lower safety limit.
MAX
Max value for lower safety limit.
Range: 0.000E+00 to 2.000E+01
Increment: 0.001
*RST: 0.000E+00
See Example "Configuring the output voltage"
Remote Control Commands
Configuration Commands
....................................................... 89
...................................................... 90
.......................................................... 90
................................................91
on page 88.
on page 88.
89