R&S NGL200 series User Manual page 83

®
R&S NGL200
*ESR?
Event status read
Returns the contents of the event status register in decimal form and then sets the reg-
ister to zero.
Return values:
<Contents>
Usage:
*IDN?
Identification
Returns the instrument identification.
Return values:
<ID>
Usage:
*OPC
Operation complete
Sets bit 0 in the event status register when all preceding commands have been execu-
ted. This bit can be used to initiate a service request. The query writes a "1" into the
output buffer when all preceding commands have been executed, which is useful for
command synchronization.
*RST
Reset
Sets the instrument to a defined default status. The default settings are indicated in the
description of commands.
Usage:
*SRE <Contents>
Service request enable
Sets the service request enable register to the indicated value. This command deter-
mines under which conditions a service request is triggered.
Parameters:
<Contents>
User Manual 1178.8736.02 ─ 02.01
Range: 0 to 255
Query only
"Rohde&Schwarz,<device type>,<part number>/<serial num-
ber>,<firmware version>"
Query only
Setting only
Contents of the service request enable register in decimal form.
Bit 6 (MSS mask bit) is always 0.
Range: 0 to 255
Remote Control Commands
Common Setting Commands
80