Command Sequence And Synchronization; Preventing Overlapping Execution; Status Reporting System - R&S NGL200 series User Manual

®
R&S NGL200
A.2 Command Sequence and Synchronization
A sequential command finishes the execution before the next command is starting. To
make sure that commands are actually carried out in a certain order, each command
must be sent in a separate command line.
As a rule, send commands and queries in different program messages.
A.2.1 Preventing Overlapping Execution
Table A-4: Synchronization using *OPC, *OPC? and *WAI
Command
*OPC
*OPC?
*WAI
To prevent an overlapping execution of commands the commands *OPC, *OPC? or
*WAI can be used. All three commands cause a certain action only to be carried out
after the hardware has been set. The controller can be forced to wait for the corre-
sponding action.
The R&S NGL200 series does not support parallel processing of remote commands. If
OPC? returns a "1", the device is able to process new commands.
A.3 Status Reporting System
The status reporting system stores all information on the current operating state of the
instrument and errors which have occurred. This information is stored in the status reg-
isters and in the error queue. You can query both via RS-232, USB, GPIB or LAN inter-
face (STATus... commands).
User Manual 1178.8736.02 ─ 02.01
Additional Basics on Remote Control
Action
Sets the Operation Complete bit
in the ESR after all previous com-
mands have been executed.
Stops command processing until
1 is returned. It occurs after the
Operation Complete bit has been
set in the ESR. This bit indicates
that the previous setting has been
completed.
Stops further command process-
ing until all commands have been
executed before *WAI.

Status Reporting System

Programming the controller
●
Setting bit 0 in the ESE
●
Setting bit 5 in the SRE
●
Waiting for service request
(SRQ)
Sending *OPC? directly after the
command whose processing
should be terminated before other
commands can be executed.
Sending *WAI directly after the
command whose processing
should be terminated before other
commands are executed
137