Advanced Operating Commands; Ramp - R&S NGL200 series User Manual

®
R&S NGL200
Usage:
ARBitrary:TRIGgered:MODE <mode>
ARBitrary:TRIGgered:MODE?
Sets/Queries the arbitrary trigger mode of the previous selected channel.
Parameters:
<mode>
ARBitrary:TRIGgered[:STATe] <state>
ARBitrary:TRIGgered[:STATe]?
Activates/Deactivates or Queries the trigger input at the rear connector (terminal block)
for arbitrary functionality..
Parameters:
<state>
Example:

7.8 Advanced Operating Commands

The VOLTage:RAMP and Sequencing subsystem contains the commands for config-
uring the ramp function and sequencing function for the output channels.

7.8.1 Ramp

[SOURce:]VOLTage:RAMP[:STATe]
[SOURce:]VOLTage:RAMP:DURation
User Manual 1178.8736.02 ─ 02.01
Setting only
SINGle | RUN
SINGle
A trigger event starts only one arbitrary sequence.
RUN
A trigger event starts the whole arbitrary sequence (with all repi-
titions).
0 | 1
0
OFF - Trigger input is deactivated.
1
ON - Trigger input is activated.
INST OUT1
ARB:TRIG ON
ARB:TRIG? -> 1
Trigger input on the rear connector is activated for Ch1 arbitrary
waveform
..................................................................................119
...............................................................................119
Remote Control Commands
Advanced Operating Commands
118