R&S NGL200 series User Manual page 118

®
R&S NGL200
ARBitrary:TRANsfer
ARBitrary:TRIGgered:MODE
ARBitrary:TRIGgered[:STATe]
ARBitrary[:STATe] <state>
ARBitrary[:STATe]?
Activates/Deactivates or Queries the arbitrary function for the previous selected chan-
nel.
Parameters:
<state>
Example:
ARBitrary:BEHavior:END <state>
ARBitrary:BEHavior:END?
Sets/Queries the arbitrary endpoint behavior, when arbitrary function is finished.
Parameters:
<state>
Example:
ARBitrary:CLEar
Clears the previous defined arbitrary waveform data for the selected channel.
Example:
Usage:
User Manual 1178.8736.02 ─ 02.01
........................................................................................................117
........................................................................................... 118
..........................................................................................118
OFF | ON | 1 | 0
ON | 1
Arbitrary function will be activated..
OFF | 0
Arbitrary function will be deactivated..
*RST: OFF | 0
Arbitrary function will be deactivated.
ARB ON
ARB? -> 1
Arbitrary function of Ch1 is activated.
See Example "Configuring an arbitrary sequence"
HOLD | OFF
OFF
If the arbitrary function is finished, the respective channel will be
deactivated automatically.
HOLD
If the arbitrary function is finished, the last arbitrary point of the
user-defined arbitrary list will be held.
*RST: OFF
See Example "Configuring an arbitrary sequence"
See Example "Configuring an arbitrary sequence"
Event
Remote Control Commands
Arbitrary Setting Commands
on page 114.
on page 114.
on page 114.
115