R&S NGL200 series User Manual page 97

®
R&S NGL200
[SOURce:]CURRent[:LEVel][:IMMediate]:STEP[:INCRement] <stepsize>
[SOURce:]CURRent[:LEVel][:IMMediate]:STEP[:INCRement]? [<stepsize>]
Sets/Queries the incremental step size for the
Setting parameters:
<stepsize>
Query parameters:
<stepsize>
Example:
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude] <current>
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]? [<current>]
Sets/Queries the current value of the selected channel.
Setting parameters:
<current>
User Manual 1178.8736.02 ─ 02.01
numeric | DEFault
numeric
Step value in A.
DEFault
Default value of stepsize.
Range: 0.0001 to 2.000
Increment: 0.0001
*RST: 0.010
Default unit: A
DEFault
Queries the default voltage step size.
INST OUT1
CURR:STEP 0.005
CURR:STEP DEF
VOLT:STEP? DEF -> 0.1000E+00
Returns the default stepsize for current.
See also Example "Configuring the current limit"
numeric | MIN | MAX | UP | DOWN
numeric
Numeric value in the range of 0.000 to 6.000.
MIN
Minimum current at 0.010 A.
MAX
Depending on the set voltage level, the maximum set current is
6.000 A.
For voltage range from 0 V to 6 V, maximum set current is 6 A.
For voltage > 6 V, maximum set currernt is 3 A.
UP
Increase current by a defined step size. See
]CURRent[:LEVel][:IMMediate]:STEP[:INCRement]
on page 94.
Remote Control Commands
Configuration Commands
CURR UP | CURR DOWN
[SOURce:
command.
on page 92.
94