R&S NGL200 series User Manual page 58

®
R&S NGL200
Figure 6-17: Overview of trigger IO system
Red lines = Hardware function
Black line = Software function
Blue
Table 6-1: Trigger-in signals
Trigger-in parameters
Inhibit Ch1
Inhibit Ch2
Ext trigger Ch1
Ext trigger Ch2
In
Output channel 1
Output channel 2
CC, CV, CR, Protection, Sink Operation Mode
User button
*TRG
User Manual 1178.8736.02 ─ 02.01
= Option is not required for these trigger-in signals
Source
Pin 1 of
Pin 2 of
Digital In, pin 2 of
connector
Digital In, pin 10 of
connector
Digital In, pin 3 of
connector
Output
User button
SCPI command (*TRG)
remotely send to instru-
ment
Descriptions
DIO connector If detected, respective channel output is turned off
if the inhibit goes active.
DIO connector
DIO If detected, corresponding trigger-out parameters
are triggered.
DIO See Table
DIO If detected, corresponding trigger-out parameters
are triggered.
See Table
If respective channel output is turned on, corre-
sponding trigger-out parameters are triggered.
See Table
If respective channel
event or sink mode is detected, corresponding
trigger-out parameters are triggered.
See Table
If detected, corresponding trigger-out parameters
are triggered.
See Table
Instrument Functions
Advanced Features
6-2.
6-2.
6-2.
output modes, protection
6-2.
6-2.
55