INVT Goodrive350 Series Operation Manual page 74

Goodrive350 series high-performance multi-function inverter
Input motor nameplate
(P02.15–P02.19)
Complete parameter
rotary autotuning
Note:
1. Motor parameters must be set correctly according to motor nameplate;
2. If rotary autotuning is selected during motor autotuning, it is a must to disconnect the motor from
load to put the motor in static and no-load state, failed to do so may lead to inaccurate autotuned
results. At this time, the asynchronous motor can autotune P02.06–P02.10, and synchronous
motor can autotune P02.20–P02.23
3. If static autotuning is selected during motor autotuning, there is no need to disconnect the motor
P00.01=0 (controlled by
Synchronous
motor
P02.00=1
Set autotuning mode
Press "RUN" key to start
Ready
keypad)
Motor type
(P02.00)
(P00.15)
Complete parameter
static autotuning
autotuning
During autotuning
Autotuning finished
-69-
Asynchronous
motor
P02.00=0
Input motor nameplate
(P02.01–P02.05)
Partial parameter rotary
autotuning
Chapter 5