Tidal Engineering Synergy Series Technical Manual page 54

Remote Start/Stop
Analog Programming
Allow Multiple Stop Steps
Synergy Controller Technical Manual, Revision H
The Remote Start/Stop Parameters:
♦ Remote Start/Stop Enable
♦ Start Input
♦ Stop Input
The Remote Start/Stop inputs can be connected to
remote switches and used to turn the controller On
and Off remotely.
The Analog Programming Feature parameters are:
♦ Programming Enabled
♦ Analog Input Select
When Analog Programming is enabled, the
controller setpoints can be set using an analog
input.
Allow Multiple Stop Steps controls a programming
option
When enabled, multiple Stop Steps are allowed in a
Synergy Controller Program. Otherwise, only one
Stop step is allowed in each program.
Page 54