Tidal Engineering Synergy Series Technical Manual page 327

Example 4
This example demonstrates the command and response for the *IDN? query. The response contains
controller information.
To setup this example we connected to the chamber as we did in Example 1, then performed the following
steps.
1. Type *IDN?" in the Command field. Note that there are NO SPACES in this command.
2. Press the Send button and note the Response field.
Note: This query is universal for GPIB equipped instruments in accordance with the IEEE 488 standard. This
command is also supported by the Synergy Controller for the TCP/IP and Serial (RS-232 and RS-485)
communication.
Synergy Controller Technical Manual, Revision H Page 327