Tidal Engineering Synergy Series Technical Manual page 306

Network Setup
To send e-mail, your controller must be connected to your network and configured for an SMTP mail server.
As always, the IP address of each Synergy Controller can be assigned by a DHCP server on your network if
available or statically entered on the controller touch screen. See Application Note 7 for information
regarding network setup.
Then setup the E-Mail configuration as shown in the next section.
Synergy Controller Technical Manual, Revision H
To begin, open the Comm Screen and browse
to the Ethernet Network folder.
Set the IP Address Selection and network
properties as required.
Page 306