Tidal Engineering Synergy Series Technical Manual page 300

"1L3 Ch 1 Setpoint Transfer Setting"
"1CTY Ch 1 Chamber Type"
"2L1 Ch 2 Main Cooling Turn-On"
"2L2 Ch 2 Main Cooling Turn-Off"
"2L3 Ch 2 Setpoint Transfer Setting"
"2CTY Ch 2 Chamber Type"
"L3 Ch 1 Main Cooling Turn-On"
"L4 Ch 1 Main Cooling Turn-Off"
"L6 Full Cooling Switch-over"
"L7 Ambient Cooling Turn-On"
"L8 Heat Ambient Cooling Turn-Off"
"L9 Ramp-Up Cooling"
"L11 Dehumidify / Vent On"
"L12 Dehumidify / Vent Off"
"L14 Time Delay Boost Cool"
"L15 Compressor Turn-off Delay"
"LEV1 Drier/Dehumid Coil"
Logging
Setup
Options
Profiles
Data
Synergy Controller Technical Manual, Revision H
"Enable Logging"
"Logging Interval (sec)"
"Log File Size (MB)"
"Log When Chamber Off"
"Log Full Behavior"
"Enable Usage Warning"
"Full Warning at %"
"Profile Storage Warning Level"
"Profile Auto-Remove Level"
Options
"Log Each Profile"
"Auto E-Mail Profile Log"
"Auto Print Profile Plot"
"Auto E-Mail Profile Plot"
"Profile Name Format"
Plot Setup
"Channel 1"
"Channel 2"
"Channel 3"
"Channel 4"
"Plot Timescale"
Channel Readings
"CH1 Actual"
"CH2 Actual"
"CH3 Actual"
"CH4 Actual"
Channel Setpoints
"CH1 Setpoint"
"CH2 Setpoint"
"CH3 Setpoint"
Cascade
"CH1 Actual"
"CH2 Actual"
Page 300